Small
·
2023
·Vol. 19
·期 49
·2303149
·
IF 13.3
Ping Li,Zhe Cheng,Jialu Liu,Lukang Che,Yingke Zhou,Enmin Xu,Xiaohui Tian,Zhongzhi Yuan
The electrode/electrolyte interfaces play an important role in the electrochemical reaction kinetics to alleviate the severe polarization and voltage hysteresis in lithium primary batteries. Herein, C 5 F 5 N is proposed as an electrolyte additive to tune the characteristics of the electrode/electrolyte interfaces. The Li/CF x primary battery with C 5 F 5 N additive exhibits an excellent discharge-specific capacity of 981.4 mAh g −1 (0.1 C), a remarkable high-rate capability of 598 mAh g −1 (15 C), and an outstanding energy/power density of 1068.7 Wh kg −1 /24362.5 W kg −1 . It also shows remarkable storage performance with 717.2 mAh g −1 at 0.1 C after storage at 55 °C for 2 months. The excellent performance of the Li/CF x batteries is closely related to the improved and stable Li 3 N/LiF-rich homogeneous interfaces induced by the C 5 F 5 N additive, which results in uniform distribution of Li + flux, facilitated electrochemical kinetics, and increased rate capability of Li/CF x battery. Therefore, C 5 F 5 N is expected to be a promising electrolyte additive, and the related electrode/electrolyte interface engineering provides an effective and facile strategy to increase the performance of the lithium primary battery.
研究领域:
材料科学
·
电化学
✓ 已验证
产品关联
DOI
PubMed
高影响因子
ACS Nano
·
2024
·
IF 15.8
Liuyi Hu,Tianqi Yang,Xiang Yan,Yaning Liu,Wenkui Zhang,Jun Zhang,Yang Xia,Yao Wang,Yongping Gan,Xinping He,Xinhui Xia,Ruyi Fang,Xinyong Tao,Hui Huang
All-solid-state lithium–sulfur batteries (ASSLSBs) have attracted wide attention due to their ultrahigh theoretical energy density and the ability of completely avoiding the shuttle effect. However, the further development of ASSLSBs is limited by the poor kinetic properties of the solid electrode interface. It remains a great challenge to achieve good kinetic properties, by common strategies to substitute sulfur–transition metal and organosulfur composites for sulfur without reducing the specific capacity of ASSLSBs. In this study, a sulfur–(Ketjen Black)–(bistrifluoromethanesulfonimide lithium salt) (S-KB-LiTFSI) composite is constructed by introducing LiTFSI into the S-KB composite. The initial discharge capacity reaches up to 1483 mA h g–1, benefited from the improved ionic conductivity and diffusion kinetics of the S-KB-LiTFSI composite, where numerous LiF interphases with a Li3N component are in situ formed during cycling. Combined with DFT calculations, it is found that the migration barriers of LiF and Li3N are much smaller than that of the Li6PS5Cl solid electrolyte. The fast ionic conductors of LiF and Li3N not only enhance the Li+ transfer efficiency but also improve the interfacial stability. Therefore, the assembled ASSLSBs operate stably for 600 cycles at 200 mA g–1, and this study provides an effective strategy for the further development of ASSLSBs.
研究领域:
材料科学
·
电化学
✓ 已验证
产品关联
DOI
PubMed
高影响因子
ELECTROCHIMICA ACTA
·
2024
·
IF 5.5
Lei Zhang,Bing Sun,Qinghua Liu,Lin Song,Teibang Zhang,Xiaobo Duan
Extensive research has focused on the lithium (Li) metal anode, but progress in developing this technology has been hindered by the formation of lithium dendrites and their irreversible effects. In this study, an inorganic LiF-Li 3 N-rich solid electrolyte interface (SEI) is established in ether electrolyte through the direct use of 2,3-difluoro-5-(trifluoromethyl)pyridine (DP) to enable uniform Li deposition and enhance interfacial properties for a stable Li metal anode. Theoretical calculations show that DP has a higher tendency to decompose on lithium metal. An alternative approach involving the inclusion of additional anions into the solvation sheath of Li + ions using weakly solvating solvents is proposed. During Li plating, DP is reduced to form a LiF and Li 3 N-rich SEI, resulting in a heterogeneous SEI layer on the Li metal anode surface. This approach allows stable cycling of Li|Li cells for over 1800 h at current densities of 5 mA cm −2 and 15 mAh cm −2 . The method presented here has potential significance in the identification of suitable electrolytes for future research on lithium metal anodes.
研究领域:
材料科学
·
电化学
·
能源存储
✓ 已验证
产品关联
DOI
高影响因子
Energy Storage Materials
·
2021
·
IF 17.789
Zhendong Li,Liyuan Huai,Shun Li,Mingming Ma,Kailin Luo,Yang Zhao,Deyu Wang,Xueliang Sun,Zhe Peng
Cycling lithium (Li) metal anode with a low negative/positive capacity (N/P) ratio is critical to build high-energy-density Li metal batteries (LMBs). Many strategies focusing on interfacial protection are limited to shallow conditions using excessive Li with a high negative/positive capacity (N/P) ratio > 50. Herein, we demonstrate a deeply enhanced charge transfer kinetic by a rational incorporation of nickel (Ni) seeds in the Li anodes with a tailored interfacial chemistry. The Ni seeds in the bulk Li anode not only act as well-dispersed nucleation sites to enable Ni-seeded growth of granular Li deposits, but also adsorb acetonitrile (AN) molecules when the Ni-seeded Li anodes are paired with an AN-based electrolyte using lithium bis-(fluorosulfonyl)imide as salt, forming a fast Li + conducting interphase with co-produced LiF, Li 3 N and Li 2 S components. These benefits conduct an exchange current density ~ 20 times higher than that of the bare Li in conventional carbonate electrolytes. Stable cycling of LMBs with a practical cathode loading (~ 5 mAh cm −2 ) and a low N/P capacity ratio of 2 is also demonstrated, showing the prominence of this remedy for developing high-energy-density LMBs.
研究领域:
材料科学
·
电化学
·
能源存储
✓ 已验证
产品关联
DOI
高影响因子
危险品化学品经营许可证（带存储）