血红蛋白含量检测试剂盒(SDS-Hb, 比色法)

货号: H1522004
有货
级别和纯度: BioReagent ? 生物试剂级(BioReagent)—— 经测试适用于生命科学和分子生物学。适用于需要生物相容性的细胞培养、检测和生化工作。
★
规格
库存
价格
数量
100T
H1522004-100T
期货 Stock Image
¥499.90
请输入您要添加的产品数量
🧪
为什么选择此级别

BioReagent 级 ,适用于对基线干扰要求严格的色谱和分析工作流程。

🌡

储存与运输

2-8°C储存,避光。低温运输 。请查阅批次 COA 获取详细规格。

📋

质量文档

SDS、COA、产品数据表及规格说明书均可下载。可通过批号查询获取批次 COA。

📚

文献证明

在色谱分析、有机合成和交叉偶联反应领域已被 0 篇同行评审文献引用。

概述

血红蛋白(Hemoglobin,Hb或HGB)是高等生物体内负责运载氧的一种蛋白质,是能使血液呈红色的蛋白,血红蛋白由四条链组成,两条α链和两条β链,每一条链有一个包含一个铁原子的环状血红素,Hb在氧含量高的区域容易与氧结合,在氧含量低的区域又容易与氧分离,血红蛋白的这一特性,使红细胞具有运输氧的功能。

现阶段,血红蛋白的检测方法主要包括:氰化高铁氧化法、碱羟测定法、十二烷基硫酸钠结合法、硫酸铜滴定法等进行血红蛋白测定,或者采用进口大型生化分析仪进行测定。氰化高铁氧化法因有氰化钾的剧毒操作问题和危废问题,硫酸铜滴定法存在自行配制误差大、易受环境温度影响等缺点,生化分析仪价格昂贵,测试成本高。

血红蛋白含量检测试剂盒(SDS-Hb, 比色法)检测原理是除硫化血红蛋白(SHb)外,血液中的各种血红蛋白均可与十二烷基硫酸钠(SDS或SLS)作用,生成SLS-Hb棕色化合物,在538nm处的吸光度与浓度成正比,根据测得的吸光度(A)可求得血红蛋白的浓度。本产品用于测定血液中血红蛋白的含量,可辅助诊断贫血、失血等情况。该产品仅用于科研领域,不适用于临床诊断或其他用途。

产品组成:

H1522004
组件 
物理外观100T储存
H1522004A
Hb标准
固体
20mg
2-8℃. 避光.
H1522004B
SLS储存液 (100×)
液体 
3mL
2-8℃. 

自备材料:

1、 去离子水或蒸馏水、生理盐水

2、 EDTA抗凝管、离心管、离心机、比色皿、分光光度计

操作步骤(仅供参考):

1、 分光光度计开机预热30min以上,调节波长至538~540nm。

2、 新鲜采集抗凝血液直接用于测定。溶血液、血清、血浆均可直接测定。血清、血浆如有浑浊请离心后取上清置于4℃备用。Hb浓度过高可用蒸馏水或生理盐水稀释2~5倍。

3、 配制Hb标准溶液:取 Hb标准20mg,加入蒸馏水1mL,即为Hb标准溶液(20mg/mL=20g/L),2~8℃保存2周。

4、 配制SLS工作液:取1份SLS储存液(100×)加99份去离子水混匀即成。

5、 加样:取离心管,按照下表设置空白管、标准管、测定管,按照顺序依次加入溶液。

加入物(单位:mL)

空白管

标准管

测定管

去离子水

0.05

—

—

Hb标准(20g/L)

—

0.05

—

待测样品

—

—

0.05

SLS工作液

2.5

2.5

2.5

充分混匀,室温下放置5min。

6、测定:波长540nm,1.0cm比色杯光径,用分光光度计测定空白管、标准管、测定管的吸光度(记为A空白、A标准、A测定)。

计算:

根据各管测得的吸光度计算样品中血红蛋白浓度。公式如下:

血红蛋白浓度(g/L)=(A测定-A空白)/(A标准-A空白)×C标准×N

式中:

C标准=标准管的血红蛋白浓度(g/L)=20(g/L)

N=样本稀释倍数

注意事项:

1、 Hb标准未用HiCN标定浓度,可能有一定误差,有特殊需求的可以自备相关标准品。

2、 实验材料应尽量新鲜,如收集血样后不立即测定,应存于4℃。

3、 标准品应防止污染,4℃密封保存。

4、 本产品线性范围为0~200g/L。样品浓度超出线性范围上限时,需将样品用生理盐水稀释,测定结果乘以稀释倍数。

5、 为了您的安全和健康,请穿实验服并戴一次性手套操作。

6、 试剂开封后请尽快使用,以防影响后续实验效果。有效期:6个月有效。低温运输,4℃保存。

Hemoglobin (Hb or HGB) is a protein responsible for oxygen transport in higher organisms and gives blood its red color. Hemoglobin consists of four chains: two α-chains and two β-chains, each containing a cyclic heme group with one iron atom. Hb readily binds oxygen in oxygen‑rich environments and releases it in oxygen‑poor environments. This property enables red blood cells to transport oxygen. 

Current methods for hemoglobin detection include: cyanmethemoglobin method, alkaline hydroxyhemoglobin method, sodium dodecyl sulfate (SDS/SLS) binding method, copper sulfate titration method, or measurement with imported large‑scale biochemical analyzers. The cyanmethemoglobin method involves toxic potassium cyanide and hazardous waste. The copper sulfate titration method has large preparation errors and is sensitive to ambient temperature. Biochemical analyzers are expensive with high testing costs. 

Principle: This Hemoglobin Content Assay Kit (SDS-Hb, Colorimetric Method) works as follows: all forms of hemoglobin in blood except sulfhemoglobin (SHb) react with sodium dodecyl sulfate (SDS or SLS) to form a brown SLS‑Hb compound. The absorbance at 538 nm is proportional to the hemoglobin concentration, allowing quantification based on absorbance (A).

For the quantitative measurement of hemoglobin content in blood samples to assist in evaluating anemia, blood loss, etc. For research use only (RUO). Not for clinical diagnosis or other applications.

Kit Components:

H1522004
Components 
Appearance
100TStorage
H1522004A
Hb standard
Solid20mg
2-8℃. Store in the dark.
H1522004B
SLS Stock Solution (100×)
Liquid 
3mL
2-8℃. 

Materials Required but Not Provided

  1. Deionized or distilled water, physiological saline
  2. EDTA anticoagulant tubes, centrifuge tubes, centrifuge, cuvettes, spectrophotometer

Procedure (For Reference Only)

1. Preheat the spectrophotometer for at least 30 min; set wavelength to 538–540 nm.

2. Use freshly collected anticoagulated blood directly. Hemolysate, serum, or plasma may also be used directly. Centrifuge turbid serum/plasma and store supernatant at 4°C until use. Dilute high‑Hb samples 2–5 fold with distilled water or saline.

3. Hb Standard Preparation: Dissolve 20 mg Hb Standard in 1 mL distilled water to make a 20 mg/mL (20 g/L) standard solution. Stable for 2 weeks at 2–8°C.

4. SLS Working Solution: Mix 1 volume of SLS Stock Solution (100×) with 99 volumes of deionized water.

5. Pipetting Scheme (Unit: mL)

ComponentBlankStandardTest
Deionized water0.05——
Hb Standard (20 g/L)—0.05—
Sample——0.05
SLS Working Solution2.52.52.5
Mix thoroughly and incubate at room temperature for 5 min.

6. MeasurementAt 540 nm with a 1.0 cm cuvette, measure absorbance of blank (A₍blank₎), standard (A₍std₎), and test (A₍test₎) samples.

Calculation

Hemoglobin Concentration (g/L) = [(A₍test₎ − A₍blank₎) / (A₍std₎ − A₍blank₎)] × C₍std₎ × N Where:

  • C₍std₎ = Hb concentration of standard = 20 g/L
  • N = sample dilution factor

Precautions

  1. The Hb Standard is not calibrated with HiCN; minor deviations may exist. Users may prepare certified standards if required.
  2. Use fresh samples whenever possible. Store samples at 4°C if not assayed immediately.
  3. Avoid contamination of the standard; store sealed at 4°C.
  4. Linear range: 0–200 g/L. Dilute samples exceeding the upper limit with saline and multiply results by dilution factor.
  5. Wear lab coats and disposable gloves for safety.
  6. Use reagents promptly after opening to avoid performance decline.

Storage & Stability

Validity: 6 months. Transport under cold conditions; store at 4℃. 

规格

别名
血红蛋白检测试剂盒(SDS-Hb比色法)
规格或纯度
BioReagent
英文名称
Hemoglobin Content Assay Kit (SDS-Hb, Colorimetric Method)
应用
细胞代谢
样品类型
血液
检测方法
比色法
检测仪器
紫外-可见光分光光度计
检测波长
538nm
敏感性
Light-sensitive
储存与运输
储存条件
2-8°C储存,避光
运输条件
低温运输
稳定性与储存
Store at 2-8℃ long term (6 months). Store in the dark.
组分与储存
H1522004
组件  物理外观100T储存
H1522004A
Hb标准 固体 20mg
2-8℃. 避光.
H1522004B
SLS储存液 (100×) 液体  3mL
2-8℃. 

技术文档

📋 安全数据表 (SDS)

全面的危险、操作、储存及法规合规文件。

下载 SDS →

✅ 分析证书 (COA)

批次质量数据。输入批号以获取对应 COA。

查询 COA →

📊 产品数据表

产品规格和应用的快速参考摘要。

查看数据表 →

🔬 规格说明书

该级别的完整质量属性和验收标准。

查看规格说明 →

高级数据

质检证书(CoA,COO,BSE/TSE 和分析图谱)
C of A & Other Certificates(BSE/TSE, COO):
输入批号以搜索分析图谱:

通过匹配包装上的批号来查找并下载产品的 COA,每批产品都进行了严格的验证,您可放心使用!

找到1个结果

批号(Lot Number) 证书类型 货号
ZJ26F0635943 分析证书 H1522004
技术文档和文章
溶液计算器