已核实 DOI 相关产品: 13

Preparation of amorphous boron coatings on graphite substrate by molten salt electrophoretic deposition

Journal 2026 · IF 5.6 · 发表于 2026 年 1 月 21 日
作者: Liwen Sun,Rong Li,Junjie Xu,Weiliang Jin,Jun Zhang,Hongmin Zhu,Saijun Xiao
阅读全文 在 PubMed 查看

摘要

Boron, owing to its excellent physicochemical properties, is utilized as a critical protective coating in numerous high-technology fields. However, conventional vapor deposition methods for fabricating boron coatings face inherent limitations, including low deposition rates, high costs, and the use of hazardous precursors. This paper, for the first time, proposes and successfully demonstrates a novel method for preparing amorphous boron coatings via molten salt electrophoretic deposition (MS-EPD). In a NaF-AlF 3 molten salt system at 970 °C, a fully dense, well-adherent, and thickness-controllable amorphous boron coating was successfully fabricated on a graphite substrate by employing boron nanopowder as the feedstock and systematically optimizing process parameters, particularly the electrophoretic voltage. It was found that the coating thickness initially increased and then decreased with rising voltage. A maximum thickness of 33 μm and an average growth rate as high as 29 μm/h were achieved, significantly surpassing those of conventional vapor deposition methods. The as-prepared amorphous boron coating also exhibited good interfacial bonding and excellent mechanical properties, with a critical load of 7.4 N and a nanoindentation hardness reaching up to 36.34 GPa. This study establishes MS-EPD as a highly efficient, cost-effective, and environmentally benign technology, opening a new avenue for the fabrication of high-performance, thick boron coatings.

本研究中使用的阿拉丁产品

13 款产品在本文中被引用