CHEMICAL ENGINEERING JOURNAL
·
2021
·
IF 13.273
Rui Huang,Hongye Wang,Cheng Tao,Hua Hao,Zhonghua Yao,Hanxing Liu,Minghe Cao
Thin film capacitors with large energy storage density and high breakdown strength are widely used in modern electronic fields. To solve the problems of interface effect and different polarization mechanism between matrix and fillers in conventional heterogeneous structure composite thin film capacitors, a new-type inorganic microcrystal-amorphous composite film of 0.92BaTiO 3 -0.08Bi(Ni 0.5 Zr 0.5 )O 3 (0.92BT-0.08BNZ) are prepared by sol–gel method. The amorphous matrix improving the breakdown strength is introduced into the film by adjusting preparation technology. Moreover, the nano-scale polar microcrystalline regions (fillers) are introduced and uniformly distributed in the amorphous matrix under various annealing temperatures. Through investigating the influence of different amorphous matrix and microcrystal trend on the dielectric and energy storage properties, it is found that synergistic effect between the polarized microcrystalline regions and the amorphous matrix are optimal at an annealed temperature of 550 ℃. The result shows that a high energy storage density of 103.7 J cm −3 and an efficiency of 88.3% are obtained under the electric field of 8.30MV cm −1 . Simultaneously, the excellent dielectric and energy storage stability is achieved in a wide temperature range of 20–200 °C. Conclusively, this microcrystal-amorphous composite film overcome the low energy storage capability and poor thermal stability of conventional composite films and provide a feasible way for preparing high energy storage performance films.
研究领域:
材料科学
·
介电材料
·
储能技术
·
无机非金属材料
·
功能薄膜
✓ 已验证
DOI
高影响因子
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
·
2019
·Vol. 31
·期 1
·542-547
·
IF 2.195
Zhang Xiuyun,Zhao Yunyun,Ling Qia,Zhu Guisheng,Zhou Xiujuan,Deng Jianqiu,Yan Dongliang,Liu Laijun,Xu Huarui,Yu Aibing
Amorphous Li–Si–Ti–P–O (LSTP) thin film electrolyte was successfully prepared by radio frequency magnetron sputtering using Li 1.4 Si 0.4 Ti 1.6 (PO 4 ) 3 powder targets and stainless steel sheet as substrate. The effects of sputtering power on the structure, morphology, ionic conductivity, and electronic conductivity of the LSTP thin film electrolyte were investigated. The results showed that the LSTP thin film electrolyte obtained with sputtering power kept at 160 W, displayed uniform particles compacted in arrangement, proper stoichiometric ratio to the powder target as well as sufficient Li-ion for diffusion. Hence, it held a considerable ionic conductivity of 4.12 × 10 −6 S cm −1 and a high σ ion / σ ele ratio about 8 magnitudes, indicating that it can be used as film electrolyte in all-solid-state lithium batteries.
研究领域:
材料科学
·
电化学
·
固态离子学
·
薄膜技术
·
能源材料
✓ 已验证
DOI
高影响因子
JOURNAL OF ALLOYS AND COMPOUNDS
·
2022
·
IF 6.371
Jianling Huang,ChengWei Liao,Hui Wang,YuJun Zhao,Liuzhang Ouyang,Jiangwen Liu,Min Zhu
Mg-based alloy anodes suffer from severe corrosion in conventional electrolytes (KOH solution) and this substantially obstructs the cycle life, which is a great challenge for using them in the Ni-MH battery. Herein, a high concentration tetramethylammonium hydroxide (TMAH) aqueous electrolyte with a special hydrate structure is explored and enables excellent cycle stability and high capacity for Mg-based alloy anodes. In this electrolyte, the Mg 0.4 Ti 0.1 Ni 0.5 alloy anode delivers a maximum discharge capacity of 466 mAh g −1 , and maintains 210 mAh g −1 after 100 cycles owing to the reduced corrosion rate , which are much better than that in 6 M KOH electrolyte, being 425 mAh g −1 and 69 mAh g −1 , respectively. Furthermore, by in-situ forming Cu coating on the Mg 0.4 Ti 0.1 Ni 0.5 electrode surface during charging process with the adding 0.01 M of Cu(OH) 2 in TMAH electrolyte, the corrosion of the electrode is further suppressed and the reversible capacity can reach 313 mAh g −1 after 100 cycles. The high conducting Cu coating can also increase the rate capability of the electrode by promoting the charge transfer. Thus, using TMAH electrolytes provides a new approach to promote the electrochemical performances of Ni-MH batteries with Mg-based alloy anodes.
研究领域:
材料科学
·
电化学
·
能源存储
·
金属腐蚀与防护
·
功能材料
·
电池技术
✓ 已验证
DOI
高影响因子
IONICS
·
2019
·Vol. 26
·期 2
·649-660
·
IF 2.289
Yan Honglin,Ru Qiang,Gao Ping,Cheng Shikun,Ling Francis Chi-Chung
In the past few years, silane coupling agents are often used to modify the surface of silicon materials; however, researches in preparation of SiO X -based materials pyrolyzed from silane coupling agents are seldom reported. Hence, in order to prepare amorphous SiO X @C anodes for Li-ion storage, we adopted three kinds of silane coupling agents as organic silicon sources. The results show that silane coupling agents with vinyl group is the optimum organic silicon source. Owing to the strong chemical bonds of Si–O–C, amorphous SiO X particles are uniformly embedded in carbon matrix, forming monodisperse microbeads architecture with good buffer abilities. Therefore, the V-SiO X @C anodes derived from silane coupling agents with vinyl groups show good electrochemical performance, retaining a reversible discharge capacity of 940 mAh g −1 at a current density of 100 mA g −1 after 200 cycles, and it still depicts a good long-term cycling durability, maintaining 739 mAh g −1 at a current density of 400 mA g −1 after 400 cycles.
研究领域:
材料科学
·
电化学
·
纳米材料
·
能源存储
·
功能材料
·
锂离子电池
✓ 已验证
DOI
高影响因子
ELECTROCHIMICA ACTA
·
2016
·
IF 4.803
Na Li,ChunYi Zhi,Haiyan Zhang
The preparation of high specific-capacity pseudocapacitive transition-metal-oxide/hydroxide (TMH) materials into transparent micro-structure electrodes is a great challenge and has become the bottleneck restricting the performance of transparent flexible supercapacitors . Beyond that, extending the operating voltage window is an urgent need for improving energy density . Here, Co(OH) 2 nanosheets and amorphous FeOOH nanowires were prepared into transparent films through a simple and scalable bio-inspired method at the air-solution interface. Both nanostructures are enwrapped in graphene shells (Co@Gr-TFandFe@Gr-TF) for use as transparent asymmetric pseudocapacitive electrodes. The unique encapsulation structures (1) provide pseudocapacitive electrode materials, especially an amorphous FeOOH structure cathode, (2) build up rapid three-dimensional electron and ion transport pathways together with the underlying ITO layer, (3) alleviate the exfoliation and dissolution of the active materials into electrolyte, and (4) extend the potential window of the FeOOH cathode from −0.8 ∼ 0 V to −1.2 ∼ 0 V with minimal cycling stability degradation. The asymmetric transparent and flexible supercapacitor based on Co@Gr-TF//Fe@Gr-TF operated at 1.8 V exhibits good transparency (50.5% at 550 nm), high specific capacitance (25.5 mF cm −2 , one order higher than the maximum value reported for FFT-GP), and high energy density (1.04 mWh cm −3 , comparable to that of nontransparent devices) as well as a long cycle life (10 000 cycles) with high-capacity retention (83.5%).
研究领域:
材料科学
·
纳米科技
·
电化学
·
能源存储
·
柔性电子学
·
功能薄膜
✓ 已验证
DOI
高影响因子
Journal of Energy Storage
·
2024
·
IF 8.9
Chunyu Xu,Yajuan Jiang,Shijie Ren,Tao Huang,Xiuyun Zhang,Guisheng Zhu,Kunpeng Jiang,Yunyun Zhao,Huarui Xu
In this paper, a facile bio-templating method is proposed to prepare NiCoP coated on amorphous carbon (NiCoP@AC) composite electrode materials with using bagasse as template and carbon source. NiCoP nanowire network arrays precursors coating on bagasse substrate with high yield were prepared via a novel synthesis strategy utilizing the toluene-water interface reaction process, which subsequently formed as NiCoP@AC composite electrode materials after phosphating process. The assembled core-shell structure attenuated the volume expansion during charging and discharging, additionally, the overall electrical conductivity of the composite was also improved owing to the characteristic of bagasse biochar. The NiCoP@AC electrode exhibited high specific capacitance (1706 F g −1 at 1 A g −1 ), outstanding rate capability (82.1 % capacity retention from 1 to 20 A g −1 ) and good cycling stability (retaining 80.0 % capacitance over 5000 cycles). In addition, bagasse biomass activated carbon (BAC) was prepared via a typical alkaline activation process for the use as negative electrode. The as-fabricated NiCoP@AC//BAC supercapacitor displayed a high energy density of 46.2 Wh kg −1 at a power density of 807.3 W kg −1 , and an excellent capacitance retention rate (88.5 % after 5000 cycles), suggesting that the as-prepared NiCoP@AC electrode materials have wide application prospects in high-performance supercapacitors.
研究领域:
材料科学
·
电化学
·
纳米材料
·
能源存储
·
生物基材料
·
功能复合材料
✓ 已验证
DOI
高影响因子
危险品化学品经营许可证（带存储）