INTERNATIONAL JOURNAL OF HYDROGEN ENERGY
·
2011
·Vol. 36
·期 14
·8203-8208
·
IF 4.057
Z.G. Zhang,H. Wang,M. Zhu
The major challenge of complex hydride for hydrogen storage is to release hydrogen at a moderate temperature with rapid kinetics. This paper reports a new composite system (NaBH 4 /ZnF 2 ) to generate hydrogen at a low temperature below 100 °C. The NaBH 4 and ZnF 2 mixture was prepared by a mechanical milling in a 2:1 M ratio. Dehydrogenation of the mixture during a heating process shows that the initial dehydrogenation temperature was below 100 °C with favorable kinetics. The structural analysis confirmed the formation of NaBF 4 and Zn in the reaction products. The study concerning the reaction mechanism reveals that ZnF 2 plays a role of reagent rather than catalyst. The produced intermediate of NaZnF 3 , however, affects the decomposition of the emitted B 2 H 6 . This work suggests that the extension of the decomposition mechanism of NaBH 4 /ZnF 2 composite system would favor the development of new catalysts for complex hydride systems.
研究领域:
材料科学
·
能源化学
·
无机化学
·
储氢技术
·
纳米催化
✓ 已验证
DOI
高影响因子
Energy Technology
·
2019
·Vol. 7
·期 6
·1801022
·
IF 3.163
Yang Liu,Qiang Ru,Yuqing Gao,Ping Gao,Fuming Chen,Lingzhi Zhao,Xianhua Hou
Antimony and red phosphorus (RP) hybrid is harvested via a facile mechanical milling strategy. Simultaneously, graphene sheets are introduced to boost the electronic transmission and mitigate the agglomeration of particles. In contrast to pristine Sb and RP electrodes, Sb/P/C hybrid affords comparably promising electrochemical performances. As anodes for lithium-ion batteries, Sb/P/C electrode depicts a reversible capacity of 869 mAh g −1 under 200 mA g −1 after 50 cycles and an excellent rate stability such as 452 mAh g −1 at 3200 mA g −1 . When used for sodium-ion batteries, the hybrid also shows moderate capacities of 544.8 and 511 mAh g −1 at the current of 50 and 200 mA g −1 after 50 cycles, respectively. These excellent properties can be ascribed to the synergetic effect of decreased particle size of milled Sb/P/C, large contact area, adequate energy storage sites, and enhanced electrical conductivity.
研究领域:
材料科学
·
电化学
·
能源存储
·
纳米材料
·
无机化学
·
固体物理
·
电池技术
✓ 已验证
DOI
高影响因子
Energy Technology
·
2020
·Vol. 8
·期 10
·2000606
·
IF 3.404
Yu Wang,Nachuan Yang,Yi Shuai,Kanghua Chen
Na 3 PS 4 -based materials, which have relatively high conductivities, make promising Na-ion solid electrolytes for realizing all-solid-state sodium batteries. Herein, Na 2.9375 PS 3.9375 Cl 0.0625 solid electrolytes’ power is prepared by a mechanical ball milling process and subsequent heat treatment process using low-cost Na, NaCl, P 2 S 5 , and S as raw materials. In addition, its electrical conductivity and electrochemical performance by compounding with polyethylene oxide–NaClO 4 are studied. The results show that Na 2.9375 PS 3.9375 Cl 0.0625 solid electrolyte heated at 550 °C with polyethylene oxide–NaClO 4 exhibits Na-ion conductivity of 8.75 × 10 −4 S cm −1 . The pragmatic and cost-effective raw materials grant the solid electrolyte with high-performance and higher practical value.
研究领域:
材料科学
·
电化学
·
能源存储
·
固体离子学
·
无机非金属材料
✓ 已验证
DOI
高影响因子
SOLID STATE IONICS
·
2016
·
IF 2.38
Shanshan Mo,Penghao Lu,Fei Ding,Zhibin Xu,Jiaquan Liu,Xingjiang Liu,Qiang Xu
Sulfide glasses with a high lithium-ion conductivity are promising solid electrolyte for all-solid-state lithium-ion batteries. In this study, 95(0.7Li 2 S–0.3P 2 S 5 )–5Li 3 PO 4 glass electrolyte is prepared by mixing 70Li 2 S-30P 2 S 5 (mol%) glass and Li 3 PO 4 crystal using mechanical milling technique. The effects on the structures and electrochemical properties of the obtained ternary sulfide glass were examined. The ternary sulfide glass shows a good electrochemical stability, which may exhibit a wide electrochemical window up to 10 V (vs. Li/Li + ). Furthermore, the 95(0.7Li 2 S-0.3P 2 S 5 )-5Li 3 PO 4 glass electrolyte displays an electrical conductivity of 2.513 × 10 − 3 S cm − 1 at 100 °C. The all-solid-state lithium-ion cell assembled with 95(0.7Li 2 S-0.3P 2 S 5 )-5Li 3 PO 4 glass electrolyte shows a favourable cyclability, which can reveal a discharge capacity of 144 mAh g − 1 at 0.05 °C and a discharge capacity of 63.9 mAh g − 1 at 0.1C after the 50th cycle at 100 °C, respectively.
研究领域:
材料科学
·
电化学
·
能源存储
·
固态离子学
·
锂电池技术
✓ 已验证
DOI
高影响因子
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY
·
2023
·Vol. 48
·期 47
·17957-17969
·
IF 7.2
Wei Zhang,Dongliang Zhao,Jun Li,Zeming Yuan,Shihai Guo,Yan Qi,Yanghuan Zhang
Ball milling the powders of Mg-based alloys with transition metal compounds is effective for improving their hydrogen storage performances. In this experiment, the alloys of La 1.7 Y 0.3 Mg 16 Ni + x wt.% TiF 3 ( x = 0–10) were prepared through mechanical milling technology. XRD , SEM , HRTEM and granulometry were used to measure the composition and microstructure of alloys. The isothermal hydrogen storage property was measured by a Sievert apparatus. The results reveal that the TiF 3 additive in ball-milled samples transforms into MgF 2 and TiH 2 after the first hydrogen absorption . Adding TiF 3 enhances the crystallinity and reduces the average particle and crystallite sizes of alloys, which is beneficial to accelerating hydriding and dehydriding kinetics. Adding 7 wt% TiF 3 into alloy decreases the dehydrogenation activation energy from 72.2 to 64.0 kJ/mol and improves the hydrogen absorption rate at low temperatures, absorbing 3.50 wt% H in 0.5 min at 323 K.
研究领域:
材料科学
·
氢能
·
金属合金
·
机械球磨
✓ 已验证
DOI
高影响因子
危险品化学品经营许可证（带存储）