计算溶液所需的质量、体积或浓度。
BioReagent,EnzymoPure™,分子生物学级,无DNA酶 级 提供 ≥95%(SDS-PAGE) 纯度,适用于对基线干扰要求严格的色谱和分析工作流程。
-20°C储存,避免反复冻融。超低温运输 。请查阅批次 COA 获取详细规格。
SDS、COA、产品数据表及规格说明书均可下载。可通过批号查询获取批次 COA。
在色谱分析、有机合成和交叉偶联反应领域已被 0 篇同行评审文献引用。
|
性能阐述:
Thermostable RNase T1 是一种基于 RNase T1 经过蛋白定向进化得到的耐热突变体。与野生型RNase T1 相比,ThermostableRNase T1 能够在 50°C的条件下保持 100% 的活性,而野生型在同样的温度下活性至少下降 50%。更高的反应温度有助于充分打开 RNA的二级结构,减少或避免其对酶切的影响,从而使酶切过程更加彻底。
活性定义
活性单位 (U) 是指在 37°C,pH7.5 条件下,以酵母 RNA 为底物,使 A260 变化 1.0 所需要的酶量。
适用范围:
1. 去除 DNA 中的 RNA;
2. 去除重组蛋白中的 RNA;
3. RNA 测序;
4. 用于核糖核酸酶保护试验(与 RNase A结合使用)
5. 测定不含 G 或低 G 含量 DNA 模板的转录水平。
适用方法
1、反应体系
组分 体积 终浓度
ssRNA
1~10 μg
50~500 ng/μL
10× RNase T1 Buffer
2 μL
1×
RNase Inhibitor (40 U/μl)*
1 μL
2 U/μL
Thermostable RNase T1 (500 U/μl)
0.4 μL
10 U/μL
Nuclease-Free Water
up to 20 μL
/
注: 为避免RNase A等环境中的RNase污染使底物RNA降解,建议在反应 体系中加入RNase Inhibitor,底物RNA应在RNase Inhibitor 加入并混匀之后加入。
2.、推荐的反应条件
50℃孵育15 min。可根据实际情况适当延长或缩短孵育时间以达 到最佳酶切效果。
注意事项:
1. Thermostable RNase T1 的热失活是可逆的,建议通过柱纯化或酚/氯仿抽提的方法去除 Thermostable RNase T1。
2. RNase 相关实验请在通风橱或特定区域进行,以避免对其他实验产生影响。
3. 为了您的安全和健康,请穿实验服并戴一次性手套及口罩进行实验操作。
|
Performance description:
Thermostable RNase T1 is a heat-resistant mutant based on RNase T1 through protein-directed evolution. Compared to wild-type RNase T1, ThermostableRNase T1 is able to maintain 100% activity at 50°C, while wild-type activity decreases by at least 50% at the same temperature. The higher reaction temperature helps to fully open the secondary structure of RNA and reduce or avoid its influence on enzyme digestion, thus making the enzyme digestion process more thorough.
Activity definition:
The activity unit (U) refers to the amount of enzyme required to change A260 by 1.0 using yeast RNA as substrate at 37°C and pH7.5.
Application:
1. Remove RNA from DNA;
2. Remove RNA from recombinant protein;
3. RNA sequencing;
4. For ribonuclease protection test (in combination with RNase A)
5. The transcription levels of DNA templates with no or low G content were measured.
Attention:
1. The thermal deactivation of Thermostable RNase T1 is reversible, and it is recommended to remove Thermostable RNase T1 by column purification or phenol/chloroform extraction.
2. Rnase-related experiments should be conducted in fume hoods or specific areas to avoid influence on other experiments.
3. For your safety and health, please wear a lab coat, disposable gloves and a mask to perform the experiment.
通过匹配包装上的批号来查找并下载产品的 COA,每批产品都进行了严格的验证,您可放心使用!
| 批号(Lot Number) | 证书类型 | 货号 |
|---|---|---|
| 分析证书 | R749974 | |
| 分析证书 | R749974 | |
| 分析证书 | R749974 |
我们的级别选择指南涵盖了目录中所有的变体的纯度、稳定剂状态和应用适用性。
查看 BioReagent 级别指南 → 查看 DNase free 级别指南 → 查看 Suitable for molecular biology 级别指南 → 查看 EnzymoPure™ 级别指南 →