计算溶液所需的质量、体积或浓度。
| 活性类型 | Relation | Activity value | Units | Action Type | 期刊 | PubMed Id | doi | Assay Aladdin ID |
|---|
,适用于对基线干扰要求严格的色谱和分析工作流程。
避光,-20°C储存。超低温运输 。请查阅批次 COA 获取详细规格。
SDS、COA、产品数据表及规格说明书均可下载。可通过批号查询获取批次 COA。
在色谱分析、有机合成和交叉偶联反应领域已被 33 篇同行评审文献引用。
Hoechst 33258,也称bis Benzimide H 33258或HOE 33258,是一种非嵌入性的亮蓝色荧光染料。染料在溶液中荧光较弱,它们在活细胞中DNA聚AT序列富集区域的小沟处与DNA结合后荧光变得明亮,故此类染料也被称为DNA探针。因背景较低,故染色细胞不需洗涤步骤,且染色非常稳定,对活细胞无毒,结合DNA染色后可持续几天或更长时间。Hoechst 33258与Hoechst 33342相比在水中的溶解度要高,但两种染料均具有高细胞膜渗透性,被广泛用于细胞凋亡检测,染色后可用荧光显微镜观察或流式细胞仪检测。 以贴壁细胞(96孔板)举例,每孔100 μL染色液,10 mL可以用于100个孔的染色。
产品参数:
Ex/Em(结合 DNA)= 352/461 nm; Ex/Em(未结合 DNA)= 346/460 nm
注意事项:
1. 使用前请将产品瞬时离心至管底,再进行后续实验。
2. 如需调整使用浓度,请选择 H598341,自行配置合适的工作液浓度。
3. 荧光染料都存在淬灭的问题,建议活细胞或组织染色后立即观察。
4. 为了您的安全和健康,请穿实验服并戴一次性手套操作。
应用范围:
细胞核染色
实验步骤:
1. 对于固定的细胞或组织
(1)对于细胞或组织样品,固定后适当洗涤去除固定剂。如需免疫荧光染色,则先进行免疫荧光染色,染色完毕后再按后续步骤进行 Hoechst 33258 染色。
(2)对于贴壁细胞或组织切片,加入少量 Hoechst 33258 工作液,覆盖住样品即可。对于悬浮细胞,至少加入待测染色样品体积 3 倍的染色液,混匀。室温放置 3-5 min。
(3)吸除 Hoechst 33258 染色液,用 TBST、PBS 或生理盐水洗涤 2-3 次,每次 3-5 min。
注:清洗步骤可选但不是必须的,清洗后不影响染色。
(4)直接在荧光显微镜下观察或封片后荧光显微镜下观察。细胞发生凋亡时,会看到凋亡细胞的细胞核呈致密浓染,或呈碎块状致密浓染。
2. 对于活细胞或组织
(1)加入适量 Hoechst 33258 工作液,充分覆盖待染色的样品,通常对于六孔板每孔需加入 1 mL 的染色液,对于 96 孔板每孔需加入 100 μL 的染色液。
(2)室温避光孵育 10-30 min。
(3)弃染色液,用 PBS 洗涤 2-3 次后添加 50 μL PBS 进行显微拍照。
注:清洗步骤可选但不是必须的,清洗后不影响染色。
Hoechst 33258, also known as bis benzimide h 33258 or hoe 33258, is a non embedding bright blfluorescent dye. Dyes have weak fluorescence in solution, and their fluorescence becomes bright after binding with DNA at the minor groove in the DNA poly at sequence rich region in living cells. Therefore, such dyes are also known as DNA probes. Because of the low background, the stained cells do not need washing steps, and the staining is very stable, non-toxic to live cells, and can last for several days or longer after combined with DNA staining. Hoechst 33258 has higher solubility in water than Hoechst 33342, but both dyes have high cell membrane permeability and are widely used for apoptosis detection. After staining, it can be observed by fluorescence microscope or detected by flow cytometry. Take adherent cells (96 well plate) as an example, 100 per well μ L staining solution, 10 ml can be used for the staining of 100 wells.
Product parameters:
Ex/em (bound DNA) = 352/461 nm; Ex/Em (unbound DNA) = 346/460 nm
Matters needing attention:
1. please centrifuge the product to the bottom of the tube immediately before use, and then conduct subsequent experiments.
2. if you need to adjust the concentration, please select H598341 and configure the appropriate working fluid concentration by yourself.
3. fluorescent dyes have quenching problems. It is recommended to observe immediately after staining live cells or tissues.
4. for your safety and health, please wear experimental clothes and disposable gloves.
Scope of application:
Nuclear staining
Experimental steps:
1. For fixed cells or tissues
(1) For cell or tissue samples, wash and remove the fixative appropriately after fixation. If immunofluorescence staining is required, first perform immunofluorescence staining, and then follow the subsequent steps to perform Hoechst 33258 staining.
(2) For adherent cells or tissue sections, add a small amount of Hoechst 33258 working solution and cover the sample. For suspended cells, add at least three times the volume of the sample to be tested and mix well. Leave at room temperature for 3-5 minutes.
(3) Remove Hoechst 33258 staining solution and wash 2-3 times with TBST, PBS, or physiological saline for 3-5 minutes each time.
Note: The cleaning steps are optional but not necessary and do not affect dyeing after cleaning.
(4) Observe directly under a fluorescence microscope or observe under a fluorescence microscope after sealing. When a cell undergoes apoptosis, the nucleus of the apoptotic cell can be seen to be densely stained or fragmented and densely stained.
2. For live cells or tissues
(1) Add an appropriate amount of Hoechst 33258 working solution and fully cover the sample to be stained. Typically, 1 mL of staining solution is required per well for a six well plate, and 100 mL is required per well for a 96 well plate μ L's staining solution.
(2) Incubate at room temperature in dark for 10-30 minutes.
(3) Discard the staining solution, wash 2-3 times with PBS, then add 50 μ Perform micrographs using PBS.
Note: The cleaning steps are optional but not necessary and do not affect dyeing after cleaning.
分类树(Taxonomy Tree)
| 界(kingdom) | 有机化合物 |
|---|---|
| 超类(Superclass) | 有机杂环化合物 |
| 类(Class) | 苯并咪唑类 |
| 亚类(Subclass) | 苯基苯并咪唑 |
| 中间层级节点(Intermediate Tree Nodes) | 暂无 |
| 直接上位类(Direct Parent) | 苯基苯并咪唑 |
| 其他上位类(Alternative Parents) | N-芳基哌嗪 苯基咪唑类 二烷基芳胺 N-甲基哌嗪 1-羟基-2-未取代苯类化合物 苯及其取代衍生物 杂芳族化合物 三烷基胺 氮杂环化合物 有机氧化合物 盐酸盐 碳氢化合物衍生物 |
| 分子骨架(Molecular Framework) | 芳香族杂多环化合物 |
| 取代基(Substituents) | 1-羟基-2-未取代苯环化合物 - 1,4-二氮杂环丁烷 - 2-苯基咪唑 - 氨基酸 - 芳香族杂多环化合物 - 氮杂环 - 吡唑 - 苯基化合物 - 二烷基芳基胺 - 杂芳香族化合物 - 烃衍生物 - 氟氯烃 - 咪唑 - 单环苯基基团 - N-烷基哌嗪 - N-芳基哌嗪 - N-甲基哌嗪 - 有机硝基化合物 - 有机氧化合物 - 有机氮化合物 - 有机氧化合物 - 苯酚 - 苯基苯并咪唑 - 哌嗪 - 三元脂肪胺 - 三级脂肪族/芳香族胺 - 三芳基胺 |
| 描述(Description) | 该化合物属于苯并咪唑类有机化合物。这类化合物具有苯并咪唑骨架结构,即咪唑环与苯基相连形成的苯并咪唑单元。 |
| 外部描述符(External Descriptors) | 暂无 |
| 作用机制 | Action Type | target ID | Target Name | Target Type | Target Organism | Binding Site Name | 参考文献 |
|---|
H302: 吞食有害
H315: 引起皮肤刺激
H319: 引起严重眼睛刺激
通过匹配包装上的批号来查找并下载产品的 COA,每批产品都进行了严格的验证,您可放心使用!
| 批号(Lot Number) | 证书类型 | 货号 |
|---|---|---|
| 分析证书 | H598341 |